RMP*Comp

Initial operational flow rate:

Cross-sectional area of pipe:

Operational pipe pressure:

(absolute)

Change in pipe elevation:

$If you're using an active mitigation measure (such as water spraying or foam coverings), use test data, manufacturer's design specifications, or your own experience to estimate the fraction of the material that is not released because of your measure. This estimate must be a number between 0 and 1. For example, if the measure prevents one-tenth of the material from being released, your estimate would be 0.1. Note that RMP*Comp assumes that any active mitigation is applied immediately at the time of release.$ Active mitigation to reduce release rate:

Fractional reduction:

(Type in a value between 0 and 1)

Mitigation measures

Check the checkbox(es) representing mitigation measure(s) in place in your process, if any.

Release into diked area:

Diked area:

Dike height:

Release into building:

Floor area:

Mitigation measures

Check the checkbox below if the following mitigation measure is in place in your process.

Release in enclosed space, in direct contact with outside air:

Fractional reduction:

(Type in a value between 0 and 1)

Errors Found

Chemical Information

Mitigation measures

Mitigation measures